Volume-1

Opencast Mining – 2

Report a question

You cannot submit an empty report. Please add some details.
0%

Opencast Mining

Opencast Mining - 2

1 / 24

1. The method of estimation in which the shape and size of the ore can be estimated is called?

2 / 24

2. The output from the surface continuous miner is.....million cu.m per year?

3 / 24

3. Wagon drill is used for the drill holes having depth of?

4 / 24

4. For every degree of the angle of inclination with the vertical the saving in explosive consumption is?

5 / 24

5. Where dragline is used before starting excavation of coal a clear space of not less than...m shall be created?

6 / 24

6. The output capacity of the dragline with 4.5 to 7.5 cu.m is......million cu.m per year?

7 / 24

7. The limitation for the inclined drilling is?

8 / 24

8. The depth to which the extraction of mineral is done economically by OCP is called?

9 / 24

9. Horizontal ledges situated on the non-productive side of the open pit and serving to accommodate the transportation roads is called?

10 / 24

10. Ripper can be compared with?

11 / 24

11. The fill factor for the Hydraulic shovel is?

12 / 24

12. The output of the shovel with 4.5 cu.m bucket is.......cu.m per year?

13 / 24

13. Jet piercing is suitable only for rocks?

14 / 24

14. The jack hammer is used for the drill holes (30mm to 40mm dia) ?

15 / 24

15. For every 1 degree deviation in slope angle changes the volume of the quarried ground by above?

16 / 24

16. The shovel can dig below ground up to...?

17 / 24

17. The limiting dip for the shovel dumper combination?

18 / 24

18. For important haul roads the minimum factor of safety of the slope is?

19 / 24

19. The limiting gradient for the continuous surface miner is?

20 / 24

20. The dumped overburden is decoaled and should not roll down at coal benches when it assumes?

21 / 24

21. The output capacity of the dragline with 23 to 30 cu.m is......million cu.m per year?

22 / 24

22. When 2 discontinuities strike obliquely and intersect on the slope face......type failure of slope occurs?

23 / 24

23. The angle of the slope of the bench wall from the horizontal is called?

24 / 24

24. The limiting gradient for the dragline is?

Your score is

The average score is 50%

0%

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button